To make this website work, we log user data and share it with processors. This is shown in Figure 6. Right after that, the display of CMU switches from Local to remote mode. Chapter 3 Updating Software Images and Configuration Files This chapter provides an overview of CLI commands that the user would employ to copy and save both configuration files and software image files. On top of this, it can be used as a full-featured More information. Hopkinton, MA www.

Uploader: Voodoojora
Date Added: 11 February 2010
File Size: 44.72 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 16993
Price: Free* [*Free Regsitration Required]

Instrument Drivers This document answers frequently. This is shown in Figure 3. To create a hardcopy by remote control, the instrument driver session must first be opened successfully and then the hardcopy device can be defined.

Also the file on the instrument will be deleted afterwards. Bluetooth is a trademark owned More information.

INSTR” seems to be the default value used in the driver vis, is the primary address of the instrument really 20 and secondary address 0?

Do you have any suggestions? Message 5 of 9.

CMU SaveRecall – Discussion Forums – National Instruments

This can be done in two steps: Most Active Software Boards: Revision Date Author Change: Reproduction without permission is lqbview. You can also try to assign a different address to the device. After the hardcopy is triggered in line 22 the generated image will be uploaded to the host PC. As stated before also in this source lqbview snippet it is important to pay attention to Figure 1.

  INTEL Q35 EXPRESS CHIPSET GRAPHICS DRIVER

As stated before also in this source code snippet it is important to pay attention to line This is done in line 36 and described in chapter 3.

How to create a Hardcopy using R&S Instrument Drivers Application Note – PDF

LabVIEW VI responsible for setting the filename and triggering of the hardcopy image Also the file on the labvidw will be deleted afterwards. Bluetooth is a trademark owned. So far, I have installed the following drivers: Also, whenever I restart the LABview and open the VI that initiates the device, the device do go in remote cmu2200 but no further communication happens and the VI keep giving labveiw same error.

The information in this guide is subject to change without notice. Message 9 of 9. It is a leading supplier of solutions in the fields of test and measurement, broadcasting, radiomonitoring and radiolocation, as well as secure communications.

Configuration Requirements for ipc Operation The hardware and operating system of the PC must comply with a list of minimum requirements for proper operation with the ipc More information. I am then unbundling each, taking the signal array in both cases. This is done in line 28 and described in chapter 3.

  AR9285 WIRELESS NETWORK ADAPTER LINUX DRIVER

LabVIEW-CMU200 help!

First initiate a hardcopy of the instruments screen and save this as a cmu2000 on the instruments hard disk and then transfer the created file to the attached PC. First Edition, March www. How do I use estimate freq. Right after that, the display of CMU switches from Local to remote mode.

This operating manual describes product handling procedures and safety precautions. Often at this stage the different file formats, page orientation, clipboard of the instruments and a connected printer can be set. How to select the proper driver for your specific environment is described in this chapter.

After the hardcopy was triggered in line 31 the generated image will be uploaded to host PC.