Waterproof should be used during the storage, transportation and running of the equipment. I already Pmed you These are global settings for all interfaces that use RIP. Got it, continue to print. This takes only a few seconds. Usually you can keep the default value: The packet with highest priority will be outputted firstly.

Uploader: Kazikree
Date Added: 6 January 2012
File Size: 29.39 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 62006
Price: Free* [*Free Regsitration Required]

Page 65 occurring in the previous x minutes. Means a complementary description. Page 71 Priority Queue Index: In ordinary TCP communication, packets are in the half-open state only briefly as a connection sries being initiated; the state changes to active when packets are being exchanged, or closed when the exchange is complete. Save the current setting into the permanent storage Reboot: The lowest port in the range should go in to the Desitnation Port From box, and the highest port in the range should go in to the Destination Port To box.

seris

This setting determines which IP Filter rules take effect, based on the security level specified in each rule. The larger the value is, the slower the refresh rate is. I have 2 PC at home and I want both of them connected.

  ARCHOS 101 G9 USB DRIVER

System provides 8 PVCs. Add IP Address max 5: Use another telephone cable to connect the splitter and the Phone Jack in the wall. Page 46 typically provide swries and secondary DNS addresses, and may provide additional addresses. Page of Srries. If the idle time of web-based management exceeds the input time, the web management will be closed. It should look something like this:. By pressing ‘print’ button you will print only current page.

Microsoft Internet Explorer 5. User name and The values shall be provided by your ISP. Don’t show me this message again. A rule will be active only if its security level is the same as the globally configured setting shown on the main IP Filter page.

The packet with highest priority will be outputted firstly. Figure RFC bridged connection-application of pure bridge The RFC bridged connection-application of pure bridge mode displays a summary of various system settings and functions as described below: Page 64 Parameter explanation Rule ID: MT will set the received traffic into one of 4 priority queues for output.

  HL DT ST DVDRAM GSA H20L DRIVER

Ip Route Table Configuration – Huawei SmartAX MT User Manual [Page 36]

The Protocol type should be set to the protocol that application you are forwarding ports for requires. You can enable or disable use of the black list using the settings described above. Page 31 Configured MTU: Port number criterion for the computer s from which the packet originates.

Show posts by this member only Post 5. Please select the eth value from pull-down menu, and click Add button as well.

Easiest Way to Forward Ports on the Huawei SMARTAX MT800 Router

In Windows Internet Explorer, you can check whether a huuawei server is enabled using the following procedures: Chapter 6 Troubleshooting 6. Then enter the highest number of that range into the Destination Port To box. Use the default user name: