If necessary, disconnect any cables connected to the card. To connect a network cable, first plug the cable into the network port or device and then plug the cable into the computer. Ensure that the assembly has had sufficient time to cool before you touch it. When you connect an IDE interface cable, do not place the colored stripe away from pin 1 of the connector. Snap the bracket onto the new drive. To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover. Instead, set the drive on a surface, such as a foam pad, that will sufficiently cushion it.

Uploader: Bracage
Date Added: 25 May 2006
File Size: 34.57 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 56428
Price: Free* [*Free Regsitration Required]

To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover. Ground yourself by touching an unpainted metal surface on the back of the computer. You can do pco by touching an unpainted metal surface on the computer chassis. If you remove your original memory modules from the computer during a memory upgrade, keep them separate from any new modules that you may have, even if you purchased the new modules from Dell.

Media Card Reader Optional. Note the routing of the DC power cables underneath the routing clips in the computer frame as you remove them from the system board and drives.

Dell Dimension – Wikipedia

Do not route card cables over d510 behind the cards. FlexBay for optional floppy drive or optional Media Card Reader. See the documentation that came with the card for information on configuring the card, making internal connections, or otherwise customizing it for your computer.

  ATI RADEON HD 5640 DRIVER DOWNLOAD

See the drive documentation in your upgrade kit for information on configuring devices for the cable select setting. If you are installing or replacing a PCI Express card, follow the procedures in the next section.

To continue using , please upgrade your browser.

Despite having a plastic shield, the heat-sink assembly may be very hot during normal operation. When installing the processor, do not touch any of the pins inside the socket or allow any objects to fall onto the pins in the socket.

To prevent static pxi to components inside your computer, discharge static electricity from your body before you touch any of your computer’s electronic components.

The pcci also keep dust and dirt out of your computer. You must position the processor correctly in the socket to avoid permanent damage to the processor and the computer when you turn on the computer.

Snap the bracket onto the new drive.

Dell Dimension

Otherwise, your computer may not start properly. Any address space reserved for these components cannot pic used by computer memory.

Some network adapters automatically start the computer when they are connected to a network. See the documentation that came with the drive for instructions on installing any software required for drive operation. If you are installing or replacing a card, follow the procedures in the next section.

When you install a filler bracket, ensure that the bracket is seated correctly.

Do not install ECC or buffered memory modules. Only unbuffered, non-ECC memory is supported. When you connect an IDE interface cable, ppci not place the colored stripe away from pin 1 of the connector. You must route these cables properly when you replace them to prevent them from being pinched or crimped.

  ML150 RAID DRIVER

After you remove the heat-sink assembly, lay the assembly on its pck. You can do so by touching an unpainted metal surface on the computer. Use care when handling the pcu release tabs to avoid damaging them. To avoid damage to the memory module, press the module straight down into the connector while you apply equal force to each end of the module.

See the label on the module to determine the module’s capacity. The mounting-bracket screws need to be removed for the removal of the system board.

You must route the DC power cables properly through the routing clips e51 you replace the cables to prevent them from being pinched or crimped.

If the new floppy drive does not include shoulder screws, use the screws within the drive panel insert. Do not set the heat-sink assembly upright or touch the thermal interface, as this may result in damage to the thermal interface material.

If your replacement hard drive does not have the hard drive bracket attached, remove the bracket from the old drive by unsnapping it from the drive.